Skip to content
EZ Break 7.0
EN NL DE
Three-quarter view of the machine.

EZ Break 7.0

Set the pressure. Get the torque.

The EZ Break 7.0 clamps drill rods and applies torque to make or break threaded connections, powered by your excavator’s auxiliary hydraulics. Start with the number that matters on site.

Open the calculator How it works

Hydraulic pressure

Set the hydraulic pressure you have available. Read the make-up or break-out torque it produces.

Full reference table →
psi
max

Reference torque

ft·lb

Reference values only. Follow the torque specification of the drill rod manufacturer and the instructions in the IOM manual.

Documentation, per machine

Scan the QR code on the type plate to reach the exact manuals and declarations that shipped with your unit.

Safety first, always

Hazards, PPE and symbols are set out plainly. Read them before you operate.

Register your warranty

Register your machine to activate its warranty and keep your documents in one place.
The machine being handled in the workshop.

Built for the trench

A break-out device for horizontal directional drilling.

It mounts to your excavator and integrates into the drilling setup. Two hydraulic clamps hold the rod; torque is applied to loosen or tighten the joint. It is not a standalone machine — it is part of your rig.

The machine, up close

The EZ Break 7.0 in the workshop — build, hydraulics and handling.

EZ Break 7.0 seen from the front.
The machine with its type plate.
Three-quarter view of the machine.
Hydraulic control block and gauges.
Hydraulic control levers.
Pressure gauges.
Hydraulic valve block.
Hydraulic cylinder and connection.

Talk to us

Talk to us

Questions about the EZ Break 7.0, specifications, or service? Send a message and we will get back to you.